Feature of Fabric Pneumatic Bursting Tester TF142C:
- Fabric Pneumatic Bursting Tester TF142C is applied to determine the bursting pressure of fabrics using pneumatic test method, including knits, woven fabric, non-woven fabric, laminated fabric, and other craft-made fabric.
- The pneumatic bursting tester controls the bursting return automatically instead of manual control by the mechanical drive. As a result, this bursting tester can avoid accidental damage to the rubber diaphragm. Besides, automatic data storage, processing, display, and printing, bursting distension measurement by the direct method rather than the traditional expansion method. With these improvements, the instrument test accuracy and its data reliability go to a higher level.
- Fabric Pneumatic Bursting Tester TF142C can also measure the specimen extension prior to bursting. When testing, the instrument applies the pneumatic test method. In addition, the instrument can display the test curve in real time via the software during the test. Moreover, there is no worry about operation safety as the device owns a transparent acrylic cover. And the operation is easy since there are four most commonly applied test areas available.
- Test principle: clamp the test specimen to the expanding diaphragm with a circular clamping ring and apply air pressure to the underside of the diaphragm. As the air pressure increases, the fabric expands until it bursts, thus determining the bursting strength and expansion rate of the specimen.
- TF142C has test process :
- Before testing, prepare the fabric bursting strength tester, cut the specimen as required and conditioning it for use.
- Select a suitable test area according to requirements. 50 cm² is suitable for most fabrics.
- Set the test parameters for the fabric bursting strength tester.
- Place the specimen on the diaphragm and clamp the specimen to prevent slippage.
- Apply pressure and start the test. At the end of the test, record the relevant data and write a test.
Specifications of Fabric Pneumatic Bursting Tester TF142C:
- Burst distension up to 70mm.
- Test Heads 100, 50, 10, 7.3 cm² (112.8, 79.8, 35.7, 30.5 mm Dia.).
- Bursting pressure up to 800KPa, accuracy ≤ ±0.2%F•S, run rate ≤60Kpa/s.
- A lamp for clear observation, a transparent acrylic cover ensures safe operation.
- Touch screen control, automatic clamping and burst test, automatic calibration, automatic data processing.
- Optional accessories: diaphragms, pack of 10.
- Test Head and Clamp 50c㎡(Φ79.8mm), 7.3c㎡(Φ30.5mm), the other sizes are available on request.
- Resolution 2Kpa.
- Power 220/110 V 50/60 Hz.
- Dimension 580mm * 450mm * 730mm.
Delivery method: Nationwide.
- Free in city. HCM
- In the station or express delivery if the customer in outside the province (customers pay shipping costs themselves)
Commitment to customers:
==> Supplying genuine goods (CO / CQ attached), 100% new (with the original belt)
==> Ensure customer's interests when buying products while in warranty, and maintenance for life.
=============== ///=============